3
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
Operation –
6 step set up for EdenPURE
™
Models 500 & 1000
1) Unpackage heater: cut open tape area, fold back flaps and gently turn
entire box upside down. Lift box from styrofoam packing. Remove
styrofoam, turn upright. We recommend keeping the packaging for off
season storage and any transporting needs.
2) Find a level and unobstructed location to place the
unpackaged heater.
3) Plug the power cord directly into an unused grounded
110 volt 15 amp or higher circuit receptacle. Push
the red rocker switch located on the front grill to the
“
I
” position to turn it on; it will glow red when
powered on.
4) Set the thermostat to the highest setting. In one to two
minutes the fan will turn on and start delivering safe
comfortable heat evenly for maximum efficiency.
5) When the temperature has reached a comfortable level, slowly
turn the thermostat down until you hear a slight click. The
thermostat will then cycle the heater on and off to maintain
your desired temperature.
6) If you press the rocker switch to the off position “
O
” during a heat
cycle, the fan will run until all internal heat has been expelled.
Cabinet Care
Wipe clean with a soft damp cloth.
Heater Storage
When the heater is not going to be used for an extended period of time,
please do the following:
1) Unplug Heater.
2) Wind up electrical cord so as to keep it off of the ground.
3) Cover the heater to prevent dust from accumulating on filter or internally.
4) Store the heater in a dry, low dust environment.
Service
To replace a heating element or for other repairs or service, please
contact the dealer you purchased your heater from or find an author-
ized service center in your area by visiting us at
www.rppurchase.com, or call us toll free at 1-866-786-8946.
Care • Operation • Service
= ON
= OFF
SAVE THESE INSTRUCTIONS
