Page 8
VAC-100-I-0315
800-638-3326 • edcoinc.com • [email protected]
EQUIPMENT DEVELOPMENT CO., INC.
GETTING STARTED WITH YOUR NEW VAC 100
VORTEX 100 STANDARD INSTRUCTIONS:
MOTOR COVER DISASSEMBLY FOR ELECTRO BRUSH INSPECTION
Turn the machine off, then
disconnect the power source.
Disconnect motor terminal.
Loosen the motor retaining knobs
enough to remove motor under
negative pressure.
Remove the 6 screws attached to
motor assembly.
Remove the plastic motor cover
to access the top of the motor.
Remove the 2 metal motor-cap-
retaining clips located on motor
(for Amatec motors only)
NOTE:
7KHSUHVHQFHRIPDWHULDOLQWKLVDUHDRULQWKHH[KDXVWLVRIWHQWKHUHVXOWRIPLVDOLJQHGVHDORUGDPDJHG¿OWHU&RQVXOW\RXU('&2
representative if either is the case.
See page 9 for AMETEK Motor
Brush inspection instructions
See page 10 for ELECTRO Motor
Brush inspection instructions
