3
REV. 03/2015
DRIVE UNIT
Refer to Figure 01204. Knock out the motor (index
13)and pick out the oil seal (index 14).After the six
screws (index 15) have been removed, knock out
the gear ring (index 16) and the bearings (index 17)
.Then the drive wheel can be changed.
Change the brushes
If the brushes (index 7) must be repalced,the motor
will have to be dismantled.
Unfasten the three screws (index 1),Open the
moter.Remove the four screws (index 5) and pick
out the brush holder (index 6).Then the brushes
(index 7) can be replaced.Refer to Figure 01205.
