background image

13

SCT

MT

EN

Country of Purchase

Horizon Hobby

Contact Information

Address

United States of America

Horizon Service Center

(Repairs and Repair Requests)

servicecenter.horizonhobby.com/

RequestForm/

4105 Fieldstone Rd 

Champaign, Illinois, 61822 USA

Horizon Product Support

(Product Technical Assistance)

[email protected]
877-504-0233

Sales

[email protected]
800-338-4639

European Union

Horizon Technischer Service

[email protected]

Hanskampring 9

D 22885 Barsbüttel, Germany

Sales: Horizon Hobby GmbH

+49 (0) 4121 2655 100

FCC ID: 2AI3D-SS0001

This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to part 15 of the FCC Rules.  

These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause 

harmful interference to radio communications.
However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can 

be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the 

following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment to an outlet on a circuit different from  

 

that to which the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for  

 help.

This device complies with part 15 of the FCC rules. Operation 

is subject to the following two conditions: (1) This device may 

not cause harmful interference, and (2) this device must accept 

any interference received, including interference that may cause 

undesired operation. 

NOTICE:

 Modifi cations to this product will void the user’s authority 

to operate this equipment.

This product contains a radio transmitter with wireless technology 

which has been tested and found to be compliant with the applicable 

regulations governing a radio transmitter in the 2.400GHz to 

2.4835GHz frequency range.

Antenna Separation Distance

When operating your transmitter, please be 

sure to maintain a separation distance of at 

least 20 cm between your body (excluding 

fi ngers, hands, wrists, ankles and feet) 

and the antenna to meet RF exposure 

safety requirements as determined by FCC 

regulations.
This illustration shows the approximate 

20 cm RF exposure area and typical hand 

placement when operating your transmitter.

20cm

EU Compliance Statement:

Horizon Hobby, LLC  hereby declares that this product is in compliance with the essential requirements and other relevant provisions 

of the RED and EMC Directives. A copy of the EU Declaration of Conformity is available online at:

http://www.horizonhobby.com/content/support-render-compliance.

Instructions for disposal of WEEE by users in the European Union

This product must not be disposed of with other waste. Instead, it is the user’s responsibility to dispose of their waste equipment by 

handing it over to a designated collections point for the recycling of waste electrical and electronic equipment. The separate collection 

and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled 

in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for 

recycling, please contact your local city offi ce, your household waste disposal service or where you purchased the product.

FCC INFORMATION

CONTACT INFORMATION

IC INFORMATION

COMPLIANCE INFORMATION FOR THE EUROPEAN UNION

IC: 21682-SSTC9202

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired 

operation of the device.

Summary of Contents for Ruckus ECX03242




















Reviews: