10
SCT
MT
EN
Description
Tapping Binder Head, M3×8mm
Tapping Binder Head, M2.5×4mm
Tapping Binder Head, M3×10mm
Tapping Binder Head, M3×14mm
Tapping Binder Head, M3×16mm
Tapping Binder Head, M3×18mm
Tapping Binder Head, M3×20mm
Tapping Binder Head, M3×22mm
Tapping Binder Head, M3×25mm
Binder Head, M3×10mm
Tapping Flat Head, M2.5×10mm
Tapping Flat Head, M3×10mm
Tapping Flat Head, M3×15mm
Tapping Binder Head, M3×12mm
Washer,
6.2×10.8×0.2mm
Flanged Lock Nut, M4
Washer,
3×8×1mm
Lock Nut M3
Washer,
2.6×6 ×0.5mm
Lock Nut M2.5
Setscrew, M3×3mm
Setscrew, M4×3mm
Binder Head, M3×20mm
Binder Head, M3×22mm
Flat Head, M3×8mm
Flat Head, M3×10mm
Flat Head, M4×18mm
Binder Head, M3×12mm
Binder Head, M3×14mm
Binder Head, M3×16mm
Binder Head, M3×18mm
Description
Description
Description
FASTENERS
SHOCK CLEANING
Oil-fi lled shocks will require regular maintenance due to the oil breaking
down or getting dirty. This maintenance should be performed after about
every 3 to 5 hours of use, depending on the conditions that the vehicle is
used in.
• Remove the shock from the vehicle.
• Remove the cap from the shock body and dispose of fluid.
• Disassemble the shock. Clean thoroughly with DYN5505. Dry parts
before assembly.
• Re-assemble the shock and refill the shock body with silicone fluid (30
weight recommended).
• Slowly move the shaft and piston up and down to remove air bubbles.
• Move the piston to the midway point of the body and install the cap.
• Wipe off any overflowing fluid.
• When properly filled, the piston should rebound about 3/8 in (9.5mm)
after being pushed in fully.
• Re-install the shock on the vehicle.
Ride Height Adjustment
Ride height is an adjustment that affects the way the vehicle jumps,
turns and goes over bumps. Drop one end of the vehicle from approxi-
mately 6 inches (152 mm) in height onto a fl at surface. When dropping
the front of the vehicle, after the vehicle settles, make sure the front
arms are equal and parallel to the fl at surface. Do the same with the
rear to make sure both arms are parallel with the fl at surface.
Lowering the front ride height increases steering, but decreases traction.
Lowering the rear ride height increases traction, but decreases steering.
Part #
Description
ECX233000
Shock, Complete, (2): 4wd
ECX233001
Shock Rebuild, (2): 4wd
ECX233002
Top, Bottom Shock Ends: 4wd
ECX233003
Shock Spring, Black, Set: 4wd
Part #
Description
ECX234005
Link Set, Plastic: 1:10 4wd All
ECX236001
Lock Nut, M2.5, (5)
ECX236004
Special Hardware: 1:10 4wd All
ECX233000
ECX233001
ECX233002
ECX234005
ECX236001
ECX236004
ECX233001
ECX233002
ECX234005
ECX233003
SHOCK PARTS
DIAGRAM
