27
Chapter 3: BIOS Setup Utility
ACPI Suspend Type
Use this item to define how your system suspends. In the default, S3 (STR), the
suspend mode is a suspend to RAM, i.e., the system shuts down with the
exception of a refresh current to the system memory.
Power Management Setup Page
This page sets some parameters for system power management operation.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
Help Item
Select the ACPI
state used for
System Suspend.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Load Default Settings
ACPI Suspend Type S3
Soft-off by PWR-BTTN Delay 4 Sec
PWRON After PWR-Fail Power Off
Resume By RING
Disabled
Resume by PCI/PCI-E/Lan PME Disabled
Resume By USB (S3) Disabled
Resume By PS2 KB (S3) Disabled
Resume By PS2 MS (S3) Disabled
Resume on RTC Alarm Disabled
Soft-off By PWR- BTTN
If the item is set to Instant-Off, then the power button causes a software power
down. If the item is set to Delay 4 Sec. then you have to hold the power button
down for four seconds to cause power down.
PWRON After PWR-Fail
This item enables your computer to automatically restart or return to its last
operating status.
Resume By Ring
The system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call on the Modem.
You must use an ATX power supply in order to use this feature.
Resume by PCI/PCI-E/Lan PME
This item specifies whether the system will be awakened from power saving
modes when activity or input signal of the specified WOL device is detected.
Resume By USB (S3)
This item allows you to enable or disable the USB device wakeup function from
S3 mode.