21
USB2/USB3: Front panel USB ports
The mainboard has two USB ports installed on the rear edge I/O port array.
Additionally, some computer cases have USB ports at the front of the case. If
you have this kind of case, use auxiliary USB connectors USB2 and USB3 to
connect the front-mounted ports to the mainboard.
Pin
Signal Name
Pin
Signal Name
1
3
5
7
9
USBPWR0
USB_FP_P0-
US
GROUND
KEY
2
4
6
8
10
USBPWR1
USB_FP_P1-
US
GROUND
USB_FP_OC0
Note:
Please make sure that the USB cable has the same pin assignment as indi-
cated above. A different pin assignment may cause damage or system
hang-up.
WOL1/WOM: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with the card to plug
into the mainboard WOL1 connector. This enables the Wake On LAN (WOL)
feature. When your system is in a power-saving mode, any LAN signal auto-
matically resumes the system.
Pin
Signal Name
1
2
3
5VSB
Ground
SENSE
If you have installed a modem, use the cable provided with the modem to plug
into the mainboard WOM1 connector. This enables the Wake On Modem
(WOM) feature. When your system is in a power-saving mode, any modem
signal automatically resumes the system. You must enable these items using
the Power Management page of the Setup Utility. See Chapter 3 for more
information.
J5 & J6: IEEE 1394A header
This header will only exist when the mainboard incorporates the SiS962
Southbridge chipset. Use this header to connect to any IEEE 1394A inte r-
face.
Pin
Signal Name
Pin
Signal Name
1
3
5
7
VCC_BUS
TPB-
TPA -
Shield
2
4
6
8
GND
TPB+
TPA+
EMPTY