ECS G31T-M, Manual

Page: 41 / 52

35
Using BIOS
Press <Esc> to return to the main menu setting page.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Power Management Setup
This page sets up some parameters for system power management operation.
Select the ACPI
state used for
System Suspend.
Help Item
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type S3
Soft-off by PWR BTTN Delay 4 Sec
PWRON After PWR-Fail Power Off
Resume by Ring Disabled
Resume by PCI/PCI-E/Lan PME Disabled
Resume by USB (S3) Disabled
Resume by PS2 KB (S3) Disabled
Resume by PS2 MS (S3) Disabled
Resume on RTC Alarm Disabled
F10: Save ESC: Exit +/-/: Value
Enter : Select
F9: Load Default Settings F1:General Help
: Move
mnlk
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.