56
SiS966/966L SATA RAID Setup Guide
8
Press <Q> again to exit this BIOS utility and the red message frame will show
as the same as the creation of the RAID 0 array. Press <Y> and <Enter> to
save changes.
9
Once the array has been created, you will need to FDISK and format the array
as if it were a new single hard drive.
Creating a RAID 0+1 (Stripe-Mirror) Array
To create a Stripe-Mirror array, follow these steps:
1
Press <A> to start creating array.
3
Press <1>%<7> keys and <Enter> to select Block Size. ( Default : 32K )
4
Press <1>%<2> keys and <Enter> to select Transfer Mode. ( Default : DMA )
2
Press <4> and <Enter> to select Strpie-Mirror.
5
Use<‘!> <“!> to select disk , and press <Enter> to select disk, <Q> to exit.