36
Using BIOS
Integrated Peripherals
This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Integrated Peripherals
Onboard IDE Controller
Both
OnBoard PCI S-ATA Controller
IDE
USB Controller
Enabled
Legacy USB Support
Enabled
OnBoard Audio Function
Enabled
OnBoard LAN Function
Enabled
Onboard LAN Boot ROM
Disabled
VIA 1394 Device
Enabled
Serial Port1 Address
3F8/IRQ4
Serial Port2 Address
2F8/IRQ3
Serial Port2 Mode
Normal
Parallel Port Address
378
Parallel Port Mode
ECP
ECP Mode DMA Channel
DMA3
Parallel Port IRQ
IRQ7
DISABLED: disabled the
integrated IDE
Controller.
PRIMARY: enables only
the Primary IDE
Controller.
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controller.
Help Item
Onboard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
Onboard PCI S-ATA Controller (IDE)
Use this item to enable or disable the onboard PCI SATA controller.
USB Controller (Enabled)
Use this item to enable or disable the USB controller.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto allows the
system to detect the presence of USB device at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled.
OnBoard Audio Function (Enabled)
Use this item to enable or disable the onboard Audio function.
OnBoard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network add-in
card with a remote boot ROM installed.
VIA 1394 Device (Enabled)
Use this item to enable or disable the onboard VIA 1394 device.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port address.
Serial Port2 Address (2F8/IRQ3)
Use this item to enable or disable the onboard COM2 serial port, and to assign a port address.
ESC: Exit
F10: Save
+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move