12
13
Before using the Manual
Override feature, make sure
the Jump Start Cable plug is
connected to the EcoJump
and the jump start clamps
are connected to the correct
polarity battery terminals.
To use the Manual Override
feature,
PRESS AND HOLD
the
Override Button
. The
READY TO JUMP
LED and
Override Indicator
LED will
flash, indicating you have
successfully entered into
Manual Override Mode and
it is ready to jump start
your vehicle.
Most vehicles will start
immediately; however, some
vehicles may require the
EcoJump to be connected
for up to 30 seconds before
starting. If the vehicle does
not start right away, wait
20-30 seconds before trying
again. Do
NOT
attempt more
than three consecutive jump
starts within a ten-minute
period. Allow the EcoJump
to rest for ten minutes before
attempting to jump start the
vehicle again.
Press the
Power Button
to exit Override Mode and
enter Standby Mode.
CAUTION:
Place your
EcoJump in
Standby Mode
before disconnecting the
jump start clamps. This
will ensure your safety.
Remember, both the spark
proof and reverse polarity
protection features are
disabled in Override Mode.
CAUTION:
Do
NOT
attempt
to jump start if unit and/or
connections are wet or damp.
Important: Maintaining Waterproofness
If the caps are not properly closed, your EcoJump is
NOT
watertight. To ensure the unit is watertight & waterproof,
ALWAYS CLOSE THE CAPS PROPERLY
.
In order to ensure the unit is watertight, close rubber caps
&
PUSH
along the
EDGE
of the
RUBBER
so that the caps
are flush with the surface of the unit.
USB Charging Connections
To access the charge
connections on the EcoJump,
pull tab on the rubber cap.
Input
Connect the USB cable to the
USB micro Input to charge
your EcoJump.
RECOMMENDATION:
Use
the USB cable and power
adapter included in the box.
NOTE:
Charge time from low
to full charge is approx. 7 hrs.
CAUTION:
Do
NOT
charge if
unit and/or connections are
wet or damp.
Output
Connect to one of the USB
Output (5V, 2.1A & 5V, 2.1A)
ports to charge your
personal device. Use the
USB cable included with
your personal device.
NOTE:
Charging rates are
similar to the charging rate
when connected to the USB
of a desktop PC.
Charge time is approx. 1.5 hrs.
from low to full for most
smartphones; however, charge
times will vary depending on
the device being charged, the
device’s battery specifications,
and the device features. In
some instances, your personal
device may not indicate if a
charge is in process.
CAUTION:
Do
NOT
charge if
unit and/or connections are
wet or damp.
OUTPUTS
INPUT
