06
07
Control Buttons & Operations
On/Off
Unit will arrive powered
OFF.
PRESS AND HOLD
the Power Button for
approximately 2 seconds
to power ON.
When ON,
SHORT PRESS
to
put in Standby Mode. Short
press again to turn unit ON.
Keep in Standby Mode when
unit is not in use to enable
battery notifications.
When ON or in Standby
Mode,
PRESS AND HOLD
for
approximately 4 seconds to
power OFF.
NOTE:
The Bluetooth battery
level and temperature
notifications do
NOT
work
when EcoJump is OFF. Refer
to
BLE and Smartphone App
for details.
Power Indicator:
• Solid
BLUE
Light - ON.
• Slow
BLUE
Flashing -
Standby Mode.
• Rapid
BLUE
Flashing -
Refer to
Extreme
Temperature Mode
for details.
• No Light - OFF.
LED Flashlight
Press the LED Button once
to cycle through four modes:
LOW, HIGH, SOS, OFF.
!
READY TO JUMP
DISCONNECT!
RECHARGE ECOJUMP
STATUS
JUMP START INSTRUCTIONS:
1.
RED
Clamp to
(+)
Terminal
2.
BLACK
Clamp to
(-)
Terminal
3. Insert Jump Start Cable
4. Press Power Button
5. Check Status Lights
POWER
PRESS:
FLASHLIGHT
HOLD:
HAZARD
OVERRIDE
Override
Indicator
Power
Indicator
Hazard
Light
Status
Lights
Battery Level Indicator
PRESS AND HOLD
to turn
the hazard light ON/OFF.
NOTE:
Unit must be ON for
lights to function.
Override
Use this function with
EXTREME
caution. Refer to
Low-Voltage Vehicle Batteries
& Manual Override
for details.
Override Indicator:
• Rapid
RED
Flashing -
Override Mode.
• No Light - Normal
Operating Mode.
Status Lights
READY TO JUMP:
Solid
GREEN
Light -
EcoJump is ready to jump
start your battery.
DISCONNECT!:
Something is connected
incorrectly -
Disconnect the
clamps immediately!
• Flashing
RED
Light -
EcoJump is likely shorted.
You must ensure clamps are
not touching each other.
• Solid
RED
Light - EcoJump
is likely connected with
reverse polarity. You must
verify that the
RED
&
BLACK
clamps are
connected to the positive
& negative battery
terminals, respectively.
Jump Start Cables
Plug
Clamps
