10
11
The EcoJump is designed
to jump start 12V lead-acid
batteries with voltage
readings down to 3.2V. If
your vehicle battery is below
3.2V, the
READY TO JUMP
LED will be OFF (even after
connecting correctly to
the POS and NEG battery
terminals). This is an
indication that the EcoJump
cannot detect a battery.
If you need to jump start a
battery below 3.2V, there is
a Manual Override feature,
which allows you to force ON
the jump start function.
CAUTION:
Use this mode
with
EXTREME CARE
. This
mode is for 12V lead-acid
batteries only.
Both
the spark proof and
reverse polarity protection
features are disabled in
Override Mode.
Pay very close attention to
the polarity of the battery
before using this mode. Do
NOT
allow the positive and
negative jump start clamps
to touch or connect to each
other as the product will
generate sparks. This mode
uses very high current (up
to 600 Amps) that can
cause sparks and high heat
if not used properly. If you
are unsure about using this
mode, do
NOT
attempt and
seek professional help.
Low-Voltage Vehicle Batteries &
Manual Override
- Use With Caution
period. Allow the EcoJump
to rest for ten minutes
before attempting to jump
start the vehicle again.
Once you have started
your vehicle, press the
Power Button on the
EcoJump to put it in
Standby Mode, unplug
the Jump Start Cables
7
NOTE:
When disconnecting,
disconnect in the reverse
sequence, removing the
negative clamp first.
Jump Start
Connect the Jump Start
Cables to the EcoJump.
Press the
Power Button
to turn ON EcoJump unit,
when in Standby Mode
(if the EcoJump is OFF,
PRESS AND HOLD
the
Power Button to turn ON).
The
Battery Level
Indicator
lights and
Power
Indicator
light will
illuminate to show the
unit is on and ready for
use. If you are connected
to a 12V battery, one of
the
Status Lights
will
also illuminate:
•
READY TO JUMP:
GREEN
light ON means
EcoJump is ready to
jump start your battery.
•
DISCONNECT!:
Something is connected
incorrectly -
Disconnect
the clamps immediately!
RED
light flashing
means EcoJump is
likely short circuited.
RED
light ON means EcoJump
is likely connected with
reverse polarity.
•
RECHARGE ECOJUMP:
YELLOW
light ON means
your EcoJump battery
level is too low to use the
jump start function.
You must recharge before
attempting to use as a
jump starter.
If the (
GREEN
)
READY TO
JUMP
LED is lit, you are
ready to proceed.
Make sure all of the
vehicle’s power loads
(headlights, radio, air
conditioning, etc.) are
turned off before
attempting to jump start
the vehicle.
Try starting the vehicle.
Most vehicles will start
immediately; however,
some vehicles may
require the EcoJump to
be connected for up to
30 seconds before
starting. If the vehicle does
not start right away, wait
20-30 seconds before
trying again. Do
NOT
attempt more than three
consecutive jump starts
within a ten-minute
3
4
from the EcoJump
unit, and disconnect the
jump start clamps from
your vehicle (removing
the negative,
BLACK
,
clamp first). Remove the
EcoJump from the vehicle
engine compartment and
store in a safe place in your
vehicle, home, or office.
6
5
