8
SPLIT-TYPE ROOM AIR CONDITIONER
EDCM
The air conditioner will control room temperature automatically
to the temperature point you set.
If you feel uncomfortable in the AUTO mode, you can set your
desired temperature.
SLEEP operation
When you push SLEEP button on remote controller during
cooling, heating(cooling & heating models only), or AUTO
operation , the air conditioner will automatically increase
(cooling) or decrease (heating) 1º C / 2º F per hour for the first
2 hours, then hold steadily for the next 5 hours, after that it will
switch off.
This mode saves you energy and brings you comfort at night.
DRYING operation
The fan speed will be automatically controlled under dry
operation.
During the dry operation, if the room temperature is lower than
10º C (50º F), the compressor stops operation and restarts until
the room temperature is above 12º C (54º F).
To achieve optimal performance, please note the following:
Adjust the air flow direction correctly so that it is not forwards
people.
Adjust the temperature to achieve the highest comfort level. Do
not adjust the unit to excessive temperature levels.
Close doors and windows on COOL or HEAT modes, or
performance may be reduced.
Use TIMER ON button on the remote controller to select a time
you want to start your air conditioner.
Do not put any object near air inlet or air outlet, as the efficiency
of the air conditioner may be reduced and the air conditioner
may stop running.
Clean the air filter periodically, otherwise cooling or heating
performance may be reduced.
Do not operate unit with horizontal louvre in closed position.
Before mainatenance
Turn the system off before cleaning. To clean, wipe with a soft,
dry cloth. Do not use bleach or abrasives.
Power supply must be disconnectd before cleaning the indoor
unit.
A cloth dampened with cold water may be used on the indoor unit
if it is very dirty. Then wipe it with a dry cloth.
Do not use a chemically treated cloth or duster to clean the unit.
Do not use benzine, thinner, polishing powder, or similar solvents
for cleaning. These may cause the plastic surface to crack or
deform.
Never use water hotter than 4º C/104 F to clean the front panel, it
could cause deformation of discoloration.
CAUTIONS
CARE AND MAINTENANCE
NOTE
OPTIMAL OPERATION
