85
7 Troubleshooting Guide
Look through the following table and locate an issue or problem you are
experiencing in the left column and read possible solutions in the right
column.
Problem
Solution
Wireless remote (thermo-
hygrometer) not reporting in
to console.
There are dashes on the
display console.
The maximum line of sight communication range is about
600’. Move the sensor assembly closer to the display
console.
Resynchronize the remote sensor(s).
Install a fresh set of batteries in the remote sensor(s).
Make sure the remote sensors are not transmitting through
solid metal (acts as an RF shield), or earth barrier (down a
hill).
Radio Frequency (RF) Sensors cannot transmit through
metal barriers (example, aluminum siding) or multiple,
thick walls.
Move the display console around electrical noise generating
devices, such as computers, TVs and other wireless
transmitters or receivers.
Outdoor sensor does not
communicate to the display
console.
The sensor may have initiated properly and the data is
registered by the console as invalid, and the console must
be reset.
Press the reset button as described in Section
Installation.
With an open ended paperclip, press the reset button for 3
seconds to completely discharge the voltage.
Take out the batteries and wait one minute, while covering
the solar panel to drain the voltage.
Put batteries back in and resync with console by powering
down and up the console with the sensor array about 10 feet
away.
Bring the sensor array inside the house (you can disconnect
Summary of Contents for HP2553
Page 59: ...59 Dashboard Graph display ...
Page 60: ...60 List display Weather Map ...
Page 72: ...72 ...
Page 74: ...74 ...
