6
Assembly Instructions
ECOWATER
S Y S T E
M S
ASSEMBLE AIR INJECTOR ADAPTOR
1.
Take a length of 1/4” tubing and push the insert
(restrictor) into one end. Then, push this end of the
tubing into the connector fitting installed in the check
valve.
2.
Take the other length of tubing and push one end
into the other connector fitting on the adaptor.
SANITIZING THE FILTER
Care is taken at the factory to keep your water filter
clean and sanitary. Materials used to make the filter
will not infect or contaminate your water supply, and
will not cause bacteria to form or grow; however, dur-
ing shipping, storage, installing and operating,
bacteria could get into the filter. For this reason, sani-
tizing, as follows, is suggested when installing.
Pour about 1 oz. or 2 oz. of the following disinfectant
into the filter.
1. Calcium hypochlorite, available in granular or tablet
form, under trade names such as Perchloron or HTH.
2. Common 5.25% household bleach such as Clorox,
Linco, Bo Peep, White Sail, Eagle, etc.
SANITIZING CONTINUED IN STEP 9, PAGE 11,
AND STEP II ON PAGE 13.
FIGURE 2
O--ring
2--7/8” x 3--1/4”
O--ring
2--3/4” x 3”
Adaptor
Float
O--ring
13/16” x 1--1/16”
Insert
(restrictor)
Check Valve
1/4” x 72” Tubing
1/4” x 72” Tubing
AIR INJECTOR ADAPTOR ASSEMBLY
Connector
Air Trap
