5
Assembly Instructions
ECOWATER
S Y S T E
M S
FILL THE MINERAL TANK
1.
Remove the adaptor assembly from the mineral
tank.
2.
Fill the tank with the gravel and birm, in that order.
Be sure the bottom distributor is centered in the
tank. Do not get gravel and birm inside the distri-
butor.
NOTE:
The birm will initially retain large amounts
of air. If it is backwashed before the air is re-
moved, the valve may get plugged with birm par-
ticles, or particles may get flushed to the drain.
To remove the air, soak the birm in water for 24 hours
prior to loading into the tank, or load the dry birm into
the tank, but do not allow the filter to regenerate until
the birm has been wetted for at least 24 hours.
INSTALL ADAPTOR ON MINERAL TANK
1.
Be sure o--ring seals are lubricated and installed
in place on the adaptor.
2.
Be sure the tank opening is clean. Then, install
the tank adaptor as shown in Figure 1. Use clamps
and retainers to fasten in place.
3.
Install the valve assembly, clamping in place.
Clamp
Retainer (4)
Clamp
Section (4)
Valve
Assembly
Adaptor
Assembly
Air Filter
TO DRAIN
(excess air)
Check Valve
Iron Filter
Tank
Connector
FIGURE 1
WARNING: FILTER
TANK CONTAINS AIR.
TO RELIEVE PRES-
SURE, PUT BYPASS
VALVE IN BYPASS AND
ADVANCE FILTER VALVE
TO BACKWASH BEFORE
DISASSEMBLY.
Remove ship-
ping cap. It is
not used.
