16
ECOWATER
S Y S T E M S
Programming the Electronic Controller (Filters)
2
. Press the
á
UP or
â
DOWN buttons to set the
number of days.
3
. When the correct number of days is displayed,
press the SELECT button, and the display will
change to show the “Set Recharge Time” screen.
SET REGENERATION STARTING TIME
1
. If you completed the previous steps, the words
“RECHARGE TIME" should show in the display
(See Figure 29). Otherwise, press the SELECT
button several times until they do.
2
. The filter’s default regeneration start time is 2:00
AM. In most households this is a good time for
regeneration to start because water is not being
used. During regeneration hard water is bypassed
to house faucets. Use the
á
UP or
â
DOWN but-
tons to adjust the recharge start time in 1 hour
increments.
3
. When the desired regeneration time is displayed,
press the SELECT button, and the display will
change to show the normal run time display.
FIG. 27
2
. Press the
á
UP or
â
DOWN buttons to set the
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
3
. When the correct time is displayed, press the
SELECT button, and the display will change to
show the “Recharge” screen.
SET DAYS BETWEEN RECHARGES
This setting is the number of days the filter will go
between recharges. The default setting is 2 days,
with a maximum setting of 99 days.
1
. If you completed the previous steps, the words
“RECHARGE" and “day” should show in the dis-
play (See Figure 28). Otherwise, press the
SELECT button several times until they do.
Complete the following programming steps if you
set the model code to “STAn”, as described on
Page 13, to use the unit as a tannin filter.
SET PRESENT TIME OF DAY
1
. If the words “PRESENT TIME" do not show in the
display, press the SELECT button several times
until they do.
FIG. 28
FIG. 30
FIG. 29
ECOWATER
S Y S T E M S
Features / Options (Filters)
ADJUSTABLE FILL
1
. Press and hold for 3 seconds the SELECT button,
until the display shows “000 - -“.
2
. Once in this display, press the SELECT button
once and “F” will appear in the display, followed by
the current fill time, in minutes, flashing.
3
. Press the
á
UP or
â
DOWN buttons to set the fill
time, from 0 to 99:59 minutes.
4
. Press the SELECT button several times to return
advance through the remaining screens and return
to the normal run (time of day) display.
FIG. 31
continued on next page
