13
ECOWATER
S Y S T E M S
Customizing Features / Options
FIG. 15
FIG. 16
FIG. 17
START A CLEAN RINSE CYCLE
To manually start a Clean Rinse cycle, press and hold the RECHARGE but-
ton for a few seconds, until “RECHARGE NOW” flashes in the display. This
Clean Rinse cycle takes 3 minutes (unless the factory settings for backwash
and fast rinse times have been changed, as shown below).
SET CLEAN RINSE START TIME
By default the Central Water Filtration System will Clean Rinse at 1:00 a.m.
The system will not filter water during the Clean Rinse cycle. It is recom-
mended that the Clean Rinse start time be set for when water is not likely to
be used in the household.
NOTE:
If you also have a water softener, set the Central Water Filtration
System’s Clean Rinse time for either one hour before or two hours
after the water softener’s scheduled regeneration time.
To change the Clean Rinse start time:
1
. Press the SELECT button a few times until “RECHARGE TIME” is shown
in the display.
2
. Press the
UP or
DOWN buttons to set the Clean Rinse time in 1
hour increments. Be sure AM or PM is correct.
3
. When the desired Clean Rinse time is displayed, press the SELECT but-
ton a few times, until the time appears in the display, but is not flashing.
12 OR 24 HOUR CLOCK
The electronic controller has been factory preset to display a 12 hour clock
(AM / PM). If you prefer, you may change this to display a 24 hour clock.
1
. Press and hold the SELECT button for a few seconds, until the “000--”
screen appears, as shown at right.
2
. Press the SELECT button once and “12 hr" will flash in the display.
3
. Use the
UP button to change to a 24 hour clock display.
4
. Press the SELECT button several times to advance through the remain-
ing screens and return to the normal operation (time of day) display.
5
. To change back to a 12 hour clock, follow Steps 1 through 4, above,
except use the
DOWN button in Step 3.
SET LENGTH OF CLEAN RINSE
By default the Central Water Filtration System’s Clean Rinse cycle will con-
sist of a 2 minute backwash followed by a 1 minute fast rinse. This should
be sufficient for most applications.
Increasing the length of Clean Rinse time will increase the amount of water
flushed to drain during each Clean Rinse cycle. Increasing the length of
Clean Rinse should only be done in cases of very high amounts of sedi-
ment, or other water issues.
continued on next page
