13
SETUP PROCEDURE
When the EcoWater Systems conditioner/refiner is
plugged in for the first time, a beep sounds and the dis-
play briefly shows a logo, followed by model informa-
tion. Next, a series of “wizard” screens prompts you to
enter basic operating information:
FIG. 26
1
.
LANGUAGE
If the desired language already has a
black dot next to it (See Figure 26), go to Step 2.
Otherwise, press the conditioner/refiner’s DOWN (
6
)
or UP (
5
) buttons to scroll to the desired language,
then press the SELECT (
¡
) button to choose it.
2
. Press the SELECT (
¡
) button to advance to the next
“wizard” screen.
FIG. 27
3
.
SYSTEM UNITS
If the desired system already has a
black dot next to it (See Figure 27), go to Step 4.
Otherwise, press the DOWN (
6
) or UP (
5
) buttons
to scroll to the desired system, then press the
SELECT (
¡
) button to choose it.
4
. Press the SELECT (
¡
) button.
FIG. 28
FIG. 29
FIG. 30
FIG. 31
FIG. 32
6
. Press the SELECT (
¡
) button.
8
. Press the SELECT (
¡
) button.
9
.
SALT LEVEL
Press the UP (
5
) or DOWN (
6
) but-
tons to set the salt level (See Figure 30). It should
match the lowest number visible on the brinewell
above the salt.
10
. Press the SELECT (
¡
) button.
11
.
IRON LEVEL
Press the UP (
5
) or DOWN (
6
) but-
tons to set the value for iron in your water (See
Figure 31). The conversion factor is 3 grains per 1
ppm of clear water iron.
12
. Press the SELECT (
¡
) button. The screen will
show “Setup complete!” (See Figure 32).
13
. If, at this point, you want to go back and make
changes, press the DOWN (
6
) button to scroll to
Redo setup
, then press the SELECT (
¡
) button
twice to repeat the “wizard” screens.
14
. If no changes are desired, make sure
Run softener
has a black dot next to it (See Figure 32) and press
the SELECT (
¡
) button. The unit begins normal
operation, described on Page 23.
FIG. 25
Display
LEFT
Button
RIGHT
Button
UP
Button
DOWN
Button
E.A.S.E.
Port
SELECT
Button
5
.
CURRENT TIME
Press the DOWN (
6
) or UP (
5
)
buttons to set the current time (See Figure 28). Hold
the button down to rapidly advance. Be sure that AM
or PM is correct. If the system units were set to met-
ric in Step 3, the clock will be in 24-hour format.
ECOWATER
S Y S T E M S
Setup Procedure for Non-Wi-Fi Systems
NOTE:
Do not increase the hardness setting to
compensate for iron in your water. The
electronic control compensates automatically
after you set the iron level in Step 11, below.
7
.
HARDNESS
Press the UP (
5
) or DOWN (
6
) but-
tons to set the value of your water’s hardness (See
Figure 29).
