© Copyright 2004 - 2016 EcoSmart Inc. All rights reserved. V251115
Burner Assembly - Natural Gas
13. route the natural gas line from below the surround unit out through
the control panel opening.
14. Using two adjustable wrenches, attach the natural gas line to
the bottom valve fitting (inlet). Do not overtighten. It is strongly
recommended to place a manual shutoff valve in the natural gas line
before it reaches the valve on the control panel.
15. Ensure the control knob (or “key”) is in the oFF position.
16. use a leak detecting solution to check all connections before
operation.
17. Plug the Ignitor wire and grounding wire into the back side of the
sparker. These wires can be plugged into either port on the back side
of the sparker box.
18. Insert the fully assembled Control Panel into the side of the
Surround Unit, feeding the cables and wires back in under the unit as
needed until the control panel is firmly in place.
19. Place the burner in the unit and remove the protective towel.
20. Fill burner area with included decorative media. Ensure burner
is completely covered before igniting the burner or burner can be
damaged.
spread Lava rock out evenly over burner area. use all Lava rock
provided for best affect. Keep clear of spark to avoid accidental
blockage. Must be spread evenly for even flame.
WARNING
Do not burn without Lava Rock on burner.
