English
8
patients from getting on by their knees.
To get on the table the patient must seat at the middle of the table, raise his legs and lean on his side.
Then, he can lie down. Weight must necessarily be distributed evenly and not concentrated on either side
of the table.
When getting down the table different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the table, lean
on his side and go up by standing on his arms. He will then be able to put his legs out by the table’s side
and easily stand up.
If the patient is lying upwards he will have to stand on his arms, get back to a seated position and then go
down the table.
* Caution: Never use the head or back rest sections to lean forward as these parts are not aimed at
supporting such a pressure.
c) Height adjustment
The central height of the table is operated by an electric motor.
The motor supplied in our electric tables is sent disconnected. Before plugging the table in, connect the air
pipes according to the attached instructions.
To operate the supply cable must be plugged into a 220-230 V socket.
For adjusting the height use the foot pedal. Press the foot control switch pedal: left downwards / right
upwards.
* Caution: Safely position patient before table height adjustment. Do not insert hands, feet or
garments into the moving parts of the elevating mechanism as this could result in serious injuries.
d) Sections adjustment
The head-/backrest section is operated by knob/lever (1)
(1) Knob/Lever: With one hand, loosen the knob or lever to release the bar. With the other hand, position
the section at the required tilting. Release the knob or lever and the section will lock itself.
* Caution: Never adjust any of the table sections while the patient is leaning on.
Safely position your fingers and hands away from the upholstery edge in order to avoid any
accidental jamming.
3) MAINTENANCE
* Warning: For safety reasons, disconnect the table from the electrical supply before the table
cleaning, repair or servicing.
a) Metal frame
For a proper operation of the table, you should do the dusting regularly with a cloth.
We also recommend to periodically grease the axles at the moving parts with a liquid grease spray. Lay
the couch on its side and take off the white caps protecting the nuts at the axles of the framework. Slightly
unscrew the nuts and spray the product around the loosen nuts. Leave to settle in this position for 12
hours. Tighten the nuts and put the protective white caps back on. Lay the table on the other side and
repeat.
Periodically check couch visually for any signs of damage and make sure that all bolts, nuts and other
fasteners are tight.
Please note that the repeated exposure of the table to high levels of humidity is not recommended.
b) Electric motor
Keep this piece free from any dust or grease. Absolutely avoid spilling liquids on the motor because they
could cause severe damage to the electric components despite the motor protection.
The handling of the electric motor is totally forbidden. Any manipulation will invalidate the
guarantee.
A non-stop blinking operation of the foot rail or any other height adjustment mechanism could activate the
