-5-
⚫
Do not remove any part installed by Econess Solar or disassemble the module.
⚫
All instructions should be read and understood before attempting to install, wire, operate
and maintain the module.
⚫
Please don
’t lift up PV modules using the attached cables or the junction box.
⚫
All PV systems must be earthed. If there is no special regulation, please follow the
National Electrical Code or other national code.
⚫
Under normal conditions, a photovoltaic module is likely to experience conditions that
produce more current and/or voltage than reported at standard test conditions.
Accordingly, the value of Isc and Voc marked on this module should be multiplied by
1.25 when determining component voltage ratings, conductor current ratings, fuse sizes,
and size of controls connected to the PV output.
⚫
Once the PV module has been shipped to the installation site, all of the parts should be
unpacked properly with care.
⚫
Do not stand or step on the PV module like below pictures show,this is prohibited
and .there is a risk of damage the module and cause injury for you.
⚫
Only PV modules with the same cell size should be connected in series.
⚫
During all transportation situations, please make sure no huge shock for the vehicle or
the modules, as this may damage the module or lead the cell to be crack.
⚫
During all transportation situation, never let the module fall down from the vehicle, house
or hands. This will break the cells of the modules.
⚫
Do not clean the glass with chemicals.
⚫
Do not disconnect any of the module when it is under load.
1.4 Fire prevention
The modules are rated fire Class C, and are suitable for mounting over a Class C roof.To
maintain the corresponding fire prevention level, the tilt angle should be no less than 5
in/ft (127 mm/305 mm) when the modules are mounted on the roof.
