ecom-CN
Page 5
2. Getting started
Once the instrument is switched on (press
key
<I/0>
) the main menu is displayed. 6
sub-menus (non visible menus can be
called up while scrolling with the arrow
keys) are listed with the following respec-
tive function:
- Gas analysis : Perform gas analysis
- Draft/Pressure : Perform draft or pressure measurement
- Soot...Oil trace
: Input of soot measurement results
- Data processing : Classify measurements/Load or send data
- Adjustments : Modify instrument adjustments
- Control
: Check instrument operation state
To start a measurement select the sub-menu
"Comb.measurem."
using the arrow keys and confirm with
<OK>
. The instrument starts a
1-minute calibration phase and the fuel types selection is displayed.
The following fuel types are selectable:
Fuel types according to 1
st
BImSchV
Fuel oil (B)
Natural gas (B)
City gas (B)
Coke oven gas (B)
Liquid gas (B)
Use the arrow keys to select the correct fuel
type and confirm with
<OK>
.
The instrument will then enquire if a data
bank function is requested. If the meas-
urement values should be attributed to a
specific plant, so press
<F1>
(
<F4>
= no:
measurement will be made without classifi-
cation).
Comb.measurem.
Draft/Pressure
Soot.Oil deriv.
Data processing
Adjustments
Control
Fuel type
Fuel oil (B)
CO2max : 15.4
A1Factor : 0.50
Select with
↑↓
!
Data processing
Quit with OK
Yes
No
Summary of Contents for CN
Page 1: ...Operating Instructions ...