18
www. EcoloBlue.com | 800-691-6043 | 1-925-231-0206
Optional Connection to Municipal (City) Water
The Atmospheric Water Generator will purify municipal (city) water if it is connected to a city water
source. Connect the city water to the Connector as shown in Figure 11, 12 and described below.
Some parts are optional. Please contact your local retailer for purchase. Use the enclosed munici-
pal water kit to connect with city water input.
1
Shut off the city water supply.
2
Remove the included Water Tap adaptor. If no threaded tap source is available contact
your local plumber for assistance. Clean the threaded end to remove any debris.
Thread the Tee Connector to the city water supply. Place the enclosed pipe tape on the
threads before making the connection. Secure with the enclosed wrench.
3
Connect the tap to the Tee Connector and water supply line. Place pipe tape on the
threads before making the connection. If no tap is needed, use the enclosed threaded
plug and pipe tape to plug the supply at the end of the Tee Connector. Secure with the
enclosed wrench.
4
Place thread tape on the threads of the Appliance’s
Input Valve
and then connect the
valve to threaded Tee Connector. Secure with the enclosed wrench.
5
Cut the water tube to the length needed for your application.
6
Remove the nut from the Input Valve.
7
Slide the nut over the water tube so that the threads face the end of the tube.
8
Place pipe tape on the threads of the Input Valve.
9
Slide the water tube over the ridge on the end of the input valve and secure the Input
Valve nut using the enclosed wrench.(Figure 11)
10
Connect the water tube to the optional filter(s) as needed.
11
At the cut end of the tube, slide the plastic connector over the end of the water tube with
the threads facing the end of the tube.
12
Insert the plastic sleeve into the end of the water tube.
13
Connect the water tube to the Appliance connection labeled WATER INLET. There is a
rubber plug inside the inlet that must be removed before connecting the tube to the
Appliance. Turn the power
OFF
(Figure 12).
14
Drain out all remaining water from the rear HOT Water Drain outlet.
15
Secure water tube hand tight.
16
Turn
ON
the water supply and check for leaks. Tighten fittings as necessary.