Patient Safeguard System Installation Tool Directions for Use Ecolab, Inc.
Page 10
Figure 6
–
Badge Mode Display, System A
4.9.7 Network Mode
Network mode is used to test the integrity of the Bentley Network in a facility. When in this mode, pressing the
Select key will cause the Tool to transmit a PSS Event over the Bentley Network, the green LED will light letting
the user know that a message has been sent. Using the dashboard, the relative strength of the signal can be
judged.
4.9.8 Menu Mode
Menu mode can be reached from any other mode by pressing the Menu key. The Up key and Down key are used
to navigate through the Menu. The Select key is used to enter the displayed mode. There are eight modes that
can be selected. Menu Mode is indicated by a blinking curser on the display.
1. Beacon mode (see section 4.9.1)
2. Bentley mode (see section 4.9.2)
3. Range Adjust mode (see section 4.9.3)
4. Bed/Stretcher mode ( see section 4.9.4)
5. Peripheral Test mode (see section 4.9.5)
6. Badge mode (see section 4.9.6)
7. Network mode (see section 4.9.7)
8. Tool Info mode (see section 4.9.9)
4.9.9 Tool Info Mode
Figure 7
–
Display in Tool Info Mode (First Screen), System A
Figure 8
–
Display in Tool Info Mode (Second Screen), System A
Selecting Tool Info mode will allow the viewing of information about the Tool. The f
irst screen displays the Tool’s
firmware revision and battery level as a percentage. Screens two through four give information about the tuning
of the antennas for the Tool’s 125 KHz receiv
er. Pressing the Menu key will return the Tool to the main menu.
4.10 Replacing the Batteries
Open the battery compartment on the back of the Tool by sliding the battery door towards the bottom end of the
Tool. Remove both old AA alkaline batteries from the battery compartment and discard. Place two new AA
alkaline batteries in the battery compartment following the diagram inside the battery compartment. Replace the
battery door back on the Tool by sliding the door towards the middle of the Tool.
Tool Firmware Revision
Tool Battery Level
Antenna Resonant Frequency
Axis Identification
Capacitor Used
Tool Mode
Badge Address
Results of Badge
Communications Test
Badge Battery Percentage
