EcoHeater NA400S Quick Start Manual Download Page 3

OPERATING INSTRUCTIONS

To begin to use the heater, please follow these instructions: 
1. Check the heater to be sure it is not structurally damaged. 
2. Then, just plug it in and then switch on the illuminated ON/OFF switch. 
3. Unplug the heater when not in use for extended periods of time.

The following is how the thermostat is used:
1. Extend (pull) the temperature sensor out from the switchbox until it stops at about 1".   The tip 

temperature sensor reads the temperature of the air, and is typically a close approximation of the room's 

ambient air temperature.
2. When the unit is first turned on, the thermostat is programmed to set at 72° Fahrenheit.  After about 3 

seconds, the digital display will show the air temperature at the tip of the temperature sensor.
3. If you desire the room temperature to be higher, then press the "+" button.
4. If you desire the room temperature to be lower, then press the "-" button.
5. If you lose power, when the power is restored the thermostat will return to the 72° Fahrenheit setting. 

AVOID THESE SITUATIONS WHEN USING YOUR ECO-HEATER

ACCESSORIES

PAINTING    

Before cleaning your heater, switch off the heater and allow it to cool. Disconnect the electricity supply to the appliance. 

The outside can be cleaned by wiping it over with a soft damp cloth and then dried. Do not use abrasive cleaning 

powders or furniture polish, as this can damage the surface finish.

CLEANING

Do not mount in front of 

electric wall outlet.

DO NOT COVER THE HEATER.

Do not use ECO-heater to dry 

clothing or any other items.

Optional thermostats, timers and heat 

reflectors are available separately.

Ceramic ECO-heaters can be painted with acrylic latex 

paint. DO NOT PAINT WITH OIL BASED PAINT. Painting or 

decorating is at the purchaser’s discretion and risk. Metal 

heaters (M400C/L/U) cannot be painted.

This heater is not intended for 

use in bathrooms, laundry 

areas, and similar locations 

where a person might be in 

contact with water and can 

also operate the unit. Never 

locate heater where it may 

fall into a bathtub or other 

water container.

Keep combustible materials 

such as furniture, beddings, 

drapes, and paper at least 3 

feet from the front of the 

heater.

THE T400 SERIES HAS AN INTEGRATED THERMOSTAT

SELECCIONE UNA UBICACIÓN ADECUADA

* El embalaje de espuma adjunto servirá como plantilla para 

taladrar.
1. Marca las posiciones de los cuatro agujeros para taladrar en 

la pared. (Instale el calentador 6 "a 18" sobre el piso para 

obtener el mejor rendimiento.)
2. Taladre agujeros con una broca del paquete de accesorios.
3. Inserte los postes de plástico de montaje en los agujeros.
4. Si está instalando un reflector de calor, siga estos pasos:

a. Coloque el reflector en el medio (equidistantes) del poste de 

montaje 4 y marque la posición de las esquinas de la pared.

b. Inicio en una esquina, despegando el papel protector de la 

parte posterior y pulse la esquina en su lugar.

c. POR FAVOR NOTA QUE EL ADHESIVO ES MUY FUERTE Y SERÁ MUY 

DIFÍCIL VOLVER A COLOCAR EL REFLECTOR DE CALOR UNA VEZ 

EMPEZAR A APLICARLO A LA PARED.

Estas características de la habitación pueden afectar la eficiencia de su calentador de ECO-Heater:

d. Continuar tirando el papel de la parte posterior mientras 

presiona el reflector en la pared, hasta que el papel se quita 

completamente.
5. Instalar el aparato en los cuatro postes de montaje que 

coinciden con los cuatro agujeros en el calentador.
6. Atornillar los 4 tornillos de fijar en los postes de montaje.
7. Poner los tapones en los pernos de apriete. Puede usarse 

pegamento para pegar las tapas en los pernos.
8. Asegúrese de que la distancia entre la parte inferior del 

calentador y el suelo es no menos de 4" cuando el 

calentador es instalado.

DESEMBALAJE E INSTRUCCIONES DE MONTAJE EN PARED

Una planta que tiene el acceso 

abierto a otras habitaciones.

Numerosas ventanas.

Habitaciones grandes pueden 

necesitar múltiples calentadores.

Aislamiento insuficiente, sin 

embargo, el uso de un térmico 

reflectante opcional escudo 

ayudará a superar este problema.

Calentador colocado cerca de una 

escalera a un piso superior.

Puerta exterior.

1.

4.

2.

3.

5.

6.

SPANISH PAGE 2

ENGLISH PAGE 3

Reviews: