Control applications manual
pGD1 control terminal
26
EN
3.
General considerations
NOTE
▪
The information included below corresponds to versions of the control applications that are available
at the date on which the document was issued. Other versions, both earlier and later, may differ
slightly from the contents found in this section.
▪
Depending on the model of the ecoSMART heat pump or accessory and its configuration, certain
screens or screen contents may not be displayed.
▪
If the following screen appears when accessing a menu, this means that the contents of that menu
are not available for that model or have not been enabled by the technical service.
4.
pGD1 control terminal
4.1.
General description
The control terminal of the heat pump consists of a display with 6 buttons, as shown in the figure below, that allow you to move
through the different menus and adjust parameters.
Figure 4.1.
pGD1 control terminal.
The general functions and operation of each of the buttons are indicated below.
The ALARMS menu can be accessed directly from anywhere in the application.
The list of user menus can be accessed from anywhere in the application.
The list of installer menus can be accessed from anywhere in the application
NOTE: It is necessary to enter access password PW1
Used to move through the menu lists.
Used to move from one screen to another inside a menu.
Used to adjust the settings of the parameters contained in a screen.
In heat pumps, used to access the heating
and cooling
outlet temperature setting screens directly from
the main screen.
Used to access the selected menu.
Used to move from one adjustable parameter to another in the same screen.
Used to access the INFORMATION menu directly from the main screen.
5h
