14
FACEPLATE TIMER FEATURES, SETTINGS AND SERVICE
NORMAL OPERATION, TIMER DISPLAYS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
During normal operation, the
present time of day, and AM or
PM, show in the time display
area. When a recharge be-
gins,
RECHARGE NOW
starts
to flash in the display, along
with the present time of day.
RECHARGE NOW
flashes un-
til the recharge is over.
feature:
RECHARGE NOW
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
For times you expect to use
more water than usual, use the
RECHARGE NOW control.
Press the Touch---Hold button
until
RECHARGE NOW
begins
to flash in the time display. A
recharge begins immediately. The filter begins to fil-
ter your water again in about 2 hours.
NOTE:
Avoid using HOT water during the recharge,
because the water heater will refill with unfiltered wa-
ter.
feature:
VACATION CONTROL
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Before going on vacation, or
other long absence, press (do
not hold in) the Touch---Hold
button so
VAC
starts to flash in
the display. The timer contin-
ues to keep time, but recharges will not occur and
waste water.
When you return,
press the Touch---Hold button
again to return the filter to service, and the present
time in the display. REMEMBER TO DO THIS, or the
filter will not recharge until you do.
NOTE:
To shut off the water supply to the filter, use
the plumbing bypass valve(s).
feature:
POWER OUTAGE MEMORY
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If electrical power to the timer is interrupted, the
“memory” built into timer circuitry keeps
all
settings
for several hours. The display is blank and the filter
will not recharge. When electrical power comes on,
one of two things will happen.
1.
The present time of day will show, meaning the
timer memory has kept all time settings.
NOTE:
If the filter was recharging when power was
lost, it will now finish the cycle.
2.
The display will show a time, but it will be flashing.
The timer memory did
not
keep the time settings and
they must be reset (page 11). The display returns to
a flashing time, then begins to keep time again. If you
do not reset the time of day, the filter will recharge
based on the days to recharge, however, recharges
will most likely be at the wrong time of day.
NOTE: The flashing display is to remind you to re-
set the timer.
If the filter was recharging when power was lost, the
valve will return to service position without finishing
the cycle. Use RECHARGE NOW (see above) to
start another cycle if needed.
feature:
ERROR CODES
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
An error code could appear in
the faceplate display if a prob-
lem occurs in the filter. If you
see an error code, for example
Err03, instead of the present time of day, please call
your local dealer for service, or see your warranty on
page 2.
