JINECO05 revB 20/06/14
Assembly
Instructions
Flue Collar and Blanking Plate
Wind the eight M6 studs supplied into the fixing
holes in the flue collar and blanking plate until
finger tight.
Place a flue gasket in position on the top plate
of the stove and lower the flue collar or
blanking plate (as required) on to the stove top,
taking care to line up the studs with the fixing
holes.
Secure in place using the M6 nuts and washers.
Slide the remaining gasket on to the studs of
the flue collar or blanking plate and secure in
place on the back plate. Unless the optional flue
damper is being fitted, blank off the damper
handle holes in the flue collar using the two M8
coach bolts.
Removing Internal
Parts
This set of instructions explains the removal
sequence that you will need to employ when
servicing your Hunter stove.
1.
Open the stove door and remove the
ash pan.
2.
Remove the fuel retainer by lifting the
right side up and sliding out from under
the door catch cover (a)
(a)
3.
Remove the baffle by pulling it forwards
and sliding it to the left until the right
side of it clears the baffle support and
then lowering it into the firebox and
removing it (b).
