Page
6
of
28
Pot Pressure Control Switch
This switch allows you to pressurize and de-pressurize the vessel with a
simple push or pull. Always make sure that the vessel is depressurized
before removing any air or blast hoses, media metering valves or the
handway assembly.
Blast Pressure Gauge
This gauge will display the vessel’s blast pressure, allowing for easy
adjustments and changes on the fly.
Blast Pressure Regulator
The regulator allows you to increase or decrease the vessel’s blast pressure,
depending on the job need. For most applications, we recommend starting
at a lower pressure and increasing slowly until appropriate pressure is
determined.
Air Supply Hose Connector
This inlet is where you connect your air supply (from either an air dryer or
directly from your air compressor). Always make sure to use both a safety
pin and a cable (aka “whip check”) to ensure operator safety.
