USER MANUAL
– MINIVAC
Page
10
of
14
INMANUUIN198 Rev.2019.11.01 / ENG
In all cases, it is better to work on tight skin. Use your free hand to tighten it during applications.
For the treatment of the neck, use low vacuum pressure to avoid marks. Apply horizontally from
the central part to the sides.
For bosom treatment, low pressure is recommended. Apply horizontally and vertically.
For back of the hands treatment, apply vertically and horizontally.
Finally, if any area had scars, wrinkles, enlarged pores, etc., it is recommended to treat it at the
end of the general exfoliation, and to work each area with the adequate tip and pressure.
5.5. POST-TREATMENT RECOMMENDATIONS
Once the microdermabrasion has been finished, wash the treated areas with some calming
cleansing agent and apply cool compresses for 10/15 minutes.
Apply moisturizing cream (preferably hypo allergenic) and sun block (SPF 15-30).
Make-up can be used immediately, but preferably not for the first 24 hours.
6. MAINTENANCE
6.1 CLEANING
Before cleaning the Ecleris Minivac, disconnect the power supply cable from the electrical
network.
6.1.1. EXTERNAL SURFACES
Clean the external surface of the equipment using a piece of cotton or cloth moistened with mild
detergent or soap. Use only adequate products for the external cleaning of electrical equipment,
prepared in accordance with the manufacturer’s indicationsl.
Perform the cleaning with special care, avoiding water or humidity access to the
equipment. Periodically check that ventilation grids are not obstructed in order to avoid
excessive temperatures.
Do not use detergents, solvents or any other abrasive agent. Do not autoclave any part of the
equipment.
It is recommended to clean the exterior surface of the equipment every 15 days.
6.1.2. VACUUM APPLICATION KIT
To clean the diamond application kit components, immerse the items in an enzymatic detergent
during the time recommended by each manufacturer. Use the provided brushes to clean the
application items under hot water until every possible adhered organic material is removed.
After cleaning, disinfect and sterilize every item.
Disinfection: Once again immerse in disinfecting liquid during the time recommended by the
manufacturer.
