USER MANUAL
– MINIVAC
Page
7
of
14
INMANUUIN198 Rev.2019.11.01 / ENG
4. INSTALLATION AND START UP
4.1. INSTALLATION
Experienced personnel are not required for the installation of the Ecleris Minivac.
1) Place the device on a flat surface.
2) Check that the plastic collecting bottle is firmly placed. Matching shall be perfect and there
shall be no air leakage. Check that the micro-porous filter is installed inside the bottle.
3) Check that the ventilation grids are free of obstructions.
4) Connect the suction hose (1.5 meter quick assembly coupling hose) to the device.
5) Connect the knurled hand piece (1) to the free end of the suction hose, pressing both parts.
There should be no air penetration and both parts should fit perfectly.
6) Screw the vacuum regulator (2) to the distal end of the knurled hand piece (1).
7) The 45º angular (3) adapter can be placed in the free end of the vacuum regulator
depending on the use: perpendicular to the tissue or at 45º. Place a 50, 75, 100, 150 or 200
microns Diamond Tip depending on the exfoliation depth desired.
O-RING COLOR
DIAMOND GRADE
White
50
Yellow
75
Orange
100
Green
150
Purple
200
8) Connect the AC interlock cable to the Ecleris Minivac. Check that the electrical network
voltage to be used is the same as the one stated in the voltage selector switch on rear panel
of the device and that the correct fuse is installed.
4.2. REVISION
Once the installation is finished, and before starting-up the device, please goes through the
following checklist:
Check that the electrical network voltage to be used is the same as the one stated in the
voltage selector switch on rear panel of the device.
Verify that the electrical network used has its grounding connection in perfect conditions,
and that it makes perfect contact with the device.
