Ecler CA200z, User Manual

Page: 12 / 92

12
4.2. Special setup mode
The CA200z's special SETUP mode can be accessed by pressing and holding the front
rotary encoder knob. This mode is for adjusting the unit's operating mode (STEREO, MONO,
BRIDGE or ZONES), setting the LCD screen contrast, recovering presets (configuration memories),
etc.:
LOAD PRESET
1 ... 5
Rotate knob
to select
PRESET
number
Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)
LOAD PRESET
1, 2, 3, 4 or 5
LP to enter
the PRESET
recovery
mode
LP
OUTPUT MODE
SETUP MODE
To enter SETUP MODE press and hold the front knob for more than 2.5 seconds
SP
SETUP MODE
DEFAULT MODE (MASTER volume control and ZONE selection)
SP to load
PRESET
and get
back
SP
Rotate knob
to browse
options
SP to get
back
LP
LP to enter
the OUTPUT
mode
selection
OUTPUT MODE
Rotate knob
to select a
mode
Rotate knob
to browse
options
LP
Rotate knob
to browse
options
LP
Press and hold MIC1 + MIC2 +
front panel knob to enter the
MIC SETUP ADVANCED MODE
Rotate knob
to browse
options
ADVANCED MODE
KEY CODE REQUIRED
MIC1 MIC2
+ +
OUTPUT LEVEL
Level: 0 to 64 (64 steps)
SP to
select
ZA or
ZB
SWITCH ZA / ZB
(only for ZONES mode)
Rotate knob
to adjust
main
output
volume
MASTER VOLUME
/ ZONE SELECT
Level
shown in
LCD
graphbar
LP
LP to enter
the SETUP
mode
PRESET
number
shown in
LCD
STEREO
MONO
BRIDGE
ZONES
Rotate knob
to browse
options
SP to get
back
VERSION INFO
vX.Y
Firmware
version
shown in
LCD
LP
Rotate knob
to browse
options
SP to get
back
LCD CONTRAST
Level: 0 to 100
Rotate knob
to adjust
level
Contrast
level shown
in LCD
LP to enter
the LCD
CONTRAST
adjust mode
LCD CONTRAST
LCD MODE
Rotate knob
to select a
mode
Mode
shown in
LCD
LP to enter
the LCD
working
MODE
LCD MODE
ON
DIMMED
OFF
SP
SP
SP
SP
Mode
shown in
LCD