3
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Installation Guide
2
Installation Guide
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Fitting Instructions
MM-4320-BT
4.3” Factory Mount Mirror Monitor
with Built-In Bluetooth
MM-4320-BT
4.3” Factory Mount Mirror Monitor
with Built-In Bluetooth
The MM-4320-BT will replace your factory fitted rearview mirror.
Remove the original mirror from the vehicle and replace with the
MM-4320-BT.
If your factory mounting bracket differs from the MM-4320-BT then there is a
supplied metal button that can be bonded to the windshield to allow the new
mirror to fit.
Once the unit is in place, run the connections cable across the headliner of
the vehicle and down the A pillar.
Please ensure that you do not impede the operation of any airbags that may
be located in the A pillar of the vehicle. Any cable passing these airbags
should be run behind the airbag and not in front of it.
Once the cable has been routed down to the dashboard, connect the camera
inputs and power connections as shown in the wiring diagram section of this
manual.
Introduction
Box Contents
Key Features
u
Factory replacement mirror
u
Bluetooth enabled with
Built-In Speaker
u
Dual video sensing inputs
u
Caller ID
u
Auto-dimming display
u
User Guide
u
Mirror Monitor
u
Main Harness
u
Universal Mounting Button
u
Cable Management
u
Allen Key
Thank you for purchasing your EchoMaster Mirror Monitor.
EchoMaster mirror monitors are designed to improve safety by providing
high quality images from camera inputs. This may help to improve vehicle
maneuvering capabilities by displaying blind spots or areas not normally
visible to the driver.
Please ensure you read and understand all aspects of this manual before
fitting or using your EchoMaster mirror monitor.
Operating Instructions
The screen will automatically turn on when it detects a signal input on either
channel. If a signal is detected on both channels then channel 2 will take
priority.
To turn off the screen, press and hold the PHONE button for 1.5 seconds.
Press again to turn it back on.
Briefly pressing the PHONE button will cycle through the 3 volume levels
available.
The screen display will auto-dim in dark conditions so as not to distract the
driver.
There are 2 reading lights in the bottom of the screen that can be turned on
by pressing the button on the underside of the MM-4320-BT.
