26
Installation Guide
26
tel - 1-866-766-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
FCTP-GM2403
Trailering Camera System
Step 6:
Connect the factory LVDS cable and GMS4-LVDS-HAR to the
GMS4 module. Make certain all connectors are fully seated
before proceeding with the install.
Step 5:
Connect the GMS4-M2F camera extension harnesses to each of the
corresponding connectors on the module. Line up the labels and connect
in the following orientation:
CONNECTIONS ON MODULE
RIGHT ----------------- GMS4-M2F-72
LEFT ------------------- GMS4-M2F-128
FRONT ---------------- GMS4-M2F-50 (Optional Front Camera)
CONNECTIONS ON GMS4-PTH-HAR
TRAILER -------------- TRAILER
OTHER --------------- TRAILER (Optional 2nd Trailer Camera)
Module Assembly and Installation (continued)
Step 7:
At this time, make sure that both DIP switches are in
the OFF position. They are only necessary if there is an
available firmware update.
DIP switches must be set prior to connecting the module
to the vehicle.
NOTE
