24
Installation Guide
24
tel - 1-866-766-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
FCTP-GM2003
Trailering Camera System
Step 3
Once the Intellihaul 2.0 home screen appears press the
corresponding button for the camera you wish to test. Pressing
the BACK button on the radios control panel will return you to
the Intellihaul 2.0 home screen.
NOTE
If a camera is not installed and the button is
pressed for that camera, a black screen will
be visible. Press the BACK button to select
another camera.
Step 4
A minor camera view adjustment is built into each of the views.
If you wish to adjust the view of the selected camera press and
hold the center of the screen for 5 seconds. Without lifting your
finger drag the image until the desired view is displayed and then
release.
Additional Testing
Activate the right turn signal. Verify the right camera is displaying on the radio’s screen.
Activate the left turn signal. Verify the left camera is displaying on the radio’s screen.
Place your foot on the brake and place the vehicle in reverse. The rear camera will display on the screen.
Place the vehicle back in park to go to back to the main display.
It is also possible to cycle through the inputs / cameras using the Keypad Tester included in the box. When
using the keypad tester, the camera label (left, right, front, rear) will be overlaid in the top left corner of the
screen to help identify which camera is being displayed. To use, connect the Keypad Tester into the GMS3-
CEH-HAR harness and press and release the button, the first camera in the rotation will be displayed. Press
and release the button again to change to the next camera. Once the camera rotation has finished, pressing
the button again will exit camera mode and return back to the main display
Once proper operation has been confirmed, ensure all factory components are in working order (radios touch
screen, radio controls, etc.) Once proper operation has been confirmed it is now time to secure any loose
components and/or cables and reassemble the vehicle.
Testing (continued)
