Echoflex Installation Guide
Temperature Sensor
Link to a Controller
The compatible target controller must be installed, powered, and within
range of the RTS.
Note:
The linking process can be used both to link a device to a
controller and to unlink a linked device from a controller.
1. Press the tab on the bottom edge of the sensor body to remove the
back plate and access the
[Teach]
button.
2. Press the
[Learn]
button on the controller to activate Link mode. If
necessary, refer to the controller product documentation.
3. Press the
[Teach]
button on the sensor once to send a link message.
An LED blinks to confirm a successful transmission.
4. Deactivate Link mode on the controller before attempting to link to
any other controllers.
Battery Power
A battery is not required for normal operation if the sensor receives
adequate natural or artificial light. See the table in the
. A CR2032 battery (not provided) may be required to run
installation tests or when the artificial light is insufficient to power the
sensor.
Sensor Back View
Teach
button
CR2032
battery
To replace the battery:
1. Remove the sensor from the back plate by
pressing the key on the lower edge of the
sensor body.
2. Use a flatblade screwdriver to remove the
old battery from the holder.
3. Insert a new battery with the positive side
(+) facing up and press in place.
4. Replace the back plate and snap it in place.
Temperature Sensor
Page 5 of 8
Echoflex
