ENGLISH
Debris Shield
WARNING
Plastic Debris Shields are equipped with a
sharp cut-off knife for cutting nylon trimmer
line to length during operation. Use extreme
care when assembling nylon line head to gear
case to avoid accidental contact with cut-off
knife. Wear work gloves when assembling
nylon line head to gear case, and avoid
contact with sharp cut-off knife edges.
Unit Configuration
GT Models:
If your Model GT curved
shaft trimmer is not fully assembled, you
must assemble the unit as instructed in the
Operator’s Manual provided with the unit.
Before using the unit, make sure the plastic
debris shield, trimmer head, and handle are
properly attached, and are securely fastened.
If your GT curved shaft trimmer has been pre-
assembled, you must make sure the plastic
debris shield, handle, and trimmer head are
properly installed and securely attached, as
shown in the Operator’s Manual provided with
the unit.
WARNING
NEVER
install a metal blade on a model GT
curved shaft trimmer. Use of any metal blade
on a GT curved shaft trimmer can result in
serious injury to operator and bystanders.
Use only nylon line heads or GT series Maxi-
Cut plastic weed trimmers approved for use
on GT models. (See Set-up Guide page 15)
Cut-Off Knife
SRM Debris Shield
GT Debris Shield
Cut-Off
Knife
Front Handle
GT Debris
Shield
Trimmer Head
GT MODEL
NO Metal
Blades
14
ASSEMBLY