G
RASS
T
RIMMER
/B
RUSH
C
UTTER
O
PERATOR
'
S
M
ANUAL
21
O
PERATION
STARTING
COLD
ENGINE
WARNING
DANGER
The cutting attachment should not rotate at idle. If attachment
rotates, readjust carburetor according to "Carburetor Adjustment"
instructions in this manual or see your ECHO Dealer, otherwise
serious personal injury may result.
1. Stop Switch - Start/Run.
Move stop switch button (A) forward away from the STOP
position.
2. Choke Lever - Cold Start.
Move choke (B) to “Cold Start” Position.
3. Primer Bulb -Prime.
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
WARNING
DANGER
Inspect starting area for hazards such as rocks, glass, debris etc.
which could be contacted by the cutting attachment when starting.
Keep helpers and bystanders at least 15 m (50 ft.) from starting
area, otherwise serious personal injury may result.
4. Lay the trimmer on a flat clear area. Firmly grasp rear handle grip
and fully depress throttle trigger to wide open position. Rapidly
pull recoil starter handle/rope (D) until engine fires (or maximum
five [5] pulls).
5. After engine fires (or five [5] pulls) move choke lever to “Run”
position. Hold throttle trigger fully depressed and pull recoil starter
handle/rope (D) until engine starts and runs. Release throttle
trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 4 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
A
B
C
D
D
Summary of Contents for SMR-2100
Page 2: ......