8
1.
POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System, Recoil Starter, and Auger Gear Case.
2.
STOP SWITCH - "SLIDE SWITCH" mounted on top of the Throttle Trigger Housing. Move switch FORWARD to
RUN, BACK to STOP.
3.
LOOP HANDLE - Operator position includes Throttle Handle Assembly and loop handle. Helper position uses loop
handle.
4.
PTO Shaft - Power Take-Off Shaft provides power to Auger accessory.
5.
AUGER ASSEMBLY - Connects to PTO Shaft. Auger Assembly is purchased separately as an accessory. See page
10 for list of auger accessories.
6.
SPARK ARRESTOR - CATALYTIC MUFFLER / MUFFLER -The muffler or catalytic muffler controls exhaust noise
and emission. The spark arrestor screen prevents hot, glowing particles of carbon from leaving the muffler. Keep
exhaust area clear of flammable debris.
7.
FUEL TANK - Contains fuel and fuel filter.
8.
RECOIL STARTER HANDLE - Pull handle slowly until starter engages, then quickly and firmly. When engine
starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.
9.
FUEL TANK CAP - Covers and seals fuel tank opening.
10. PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming the carbure-
tor for starting. Pump primer bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an
additional 4 or 5 times.
11. AIR CLEANER - Contains replaceable filter element.
12. CHOKE - Located above air cleaner housing. Move lever to starting position (
) (close choke) and back to run
position (
) (open choke).
13. AIR DEFLECTOR - Deflects hot engine cooling air away from operator.
14. GEAR CASE - Sealed Gear Case provides 30.2 to 1 reduction for best combination of power and auger speed.
Requires no user maintenance.
15. THROTTLE HANDLE ASSEMBLY - Contains main operator controls- Throttle Trigger, Stop Switch, and Throttle
Trigger Lockout.
16. THROTTLE TRIGGER LOCKOUT - Operation of the throttle trigger is prevented unless throttle trigger lockout
lever is engaged.
17. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration press throttle trigger
gradually for best operating technique.
18. DECOMPRESSION BUTTON - Push button to assist starting. Automatically resets after engine starts and runs.
19. LOWER HAND GRIP - Used for right-hand grip by Operator during two-man operation.
20. SPARK PLUG - Provides spark to ignite fuel mixture.
