Echelon 14315R, User Manual

Page: 59 / 99

LonWorks Router User’s Guide 49
Installation procedures for the LonMaker Integration Tool are described in
Chapter 6, Installing a LonWorks Router , on page 65.
The preceding four steps complete the configuration when a single custom
transceiver is used. Proceed with the following steps if two custom transceivers
are to be used with the RTR-10 router.
5.
Remove power from the RTR-10 router.
6. Disconnect the predefined transceiver from Side A.
7. Select the custom transceiver ID (type 30, 0x1E) on Side A.
8. Attach the selected custom transceiver to Side B as shown in Figure 25 ,
leaving the Side B transceiver ID set to 30 (0x1E).
Figure 25 . Configuring Side A
9. Attach a network services tool with a compatible custom transceiver to
Channel B, as shown in Figure 25 .
10. Configure the communications parameters on side A of the RTR-10 router
using the network management tool. Side B might be automatically
reconfigured at the same time depending on the network management tool.
Developing a Router with the Router 5000
To create a L
ON
W
ORKS
router with the Router 5000, perform the following steps:
1. Build a router motherboard according to the specifications described in
Chapter 2, LonWorks Router Electrical Interfaces , on page 17, and the
guidelines described in Chapter 5, LonWorks Router Design Issues , on
page 59. The motherboard can be part of custom application hardware,
or can be a standalone board. Figure 26 on page 51 and Figure 27 on
page 52 show a sample motherboard schematic for a TP/XF-1250 to EIA
485 twisted pair router.
2. Program the serial EEPROM for each router half. You can program the
EEPROMs either before assembly or in-circuit after assembly.
3. Assemble the router, including the two Router 5000 half-routers, two
transceivers, and a motherboard.