EN
34
EN
35
Setting of timer
After switching on, setting of output and temperature, you can set the timer for an automatic shutdown.
In the normal operating mode, press the timer button once, the display will flash “00:00”. Increase
the time by tapping and moving your finger along the finger slide from the left to the right in 5 minute
increments ranging between 0-55. Then tap and slide your finger along the finger slide from the left
to right in order to set the time 01-03. The time can be set between 0-235. If the timer is not set to 0,
the display will show set time. If the timer is set to 00:00, the time setting function begins to flash for
5 seconds and then switched off.
5 seconds after setting the timer, the display will show the remaining time (the light will stop flashing)
and the timer will start a countdown. When the set time will run out, the cooker will automatically shut
down. A beep will sound and the cooker will switch to a standby mode.
To cancel the timer setting, press the timer button
for 3 seconds. The indicator light next to the
button will go out and the timer setting is cancelled.
Default cooking time
There is a default setting for an automatic shut down of the cooker after 2 hours of cooking as a
precaution, in case you forget to switch it off.
Children lockout
When you press the children safety button you will switch on the control panel lockout. The indicator
light will come on and the lock is set. When the lock is set, none of the buttons on the control panel
work, except for the on/off button . To cancel the children lockout, press the children safety button
for at least 3 seconds, the light will go out and the function is cancelled.
WARNINGS
If there is something wrong, a beep will sound and a code will appear on the display:
E0
– internal component or electrical connection error
E1
– there is not pot/pan on the induction zone or the cookware is made of unsuitable material or the
diameter of the pot/pan is less than 12 cm
E2
– IGBT protection (motherboard component) against overheating
E3
– voltage is greater than 265 V
E4
– voltage is less than 160 V
E5
– heat sensor short circuit
E6
– IGBT short circuit
E7
– temperature sensor protection against overheating