ECG IV 2920 Slim, Instruction Manual, Page: 52 / 136

GB
52 52
52
4. Otherwise, it is not possible to set cooking after pressing „Menu“ button. A repeated beep sounds and
warning E0 appears on the display. The induction hob will switch to standby mode after 40 seconds.
2) Setting the power level
1. Pressing the "Function" button lights up the "Power" power level indicator.
2. After switching on, the power level is automatically set to 1600 W.
3. Use the “+/-” buttons to set the desired power level in the range of 200-1600 W (10 settings in total).
3) Setting the temperature
1. Press the “Function” button twice and the set temperature indicator “°C” lights up.
2. After switching on, the temperature is automatically set to 240 °C.
3. Use the “+/-” buttons to set the temperature to the desired level between 60–240 °C (10 settings in total).
4) Setting the timer
• Press the “Timer” button and set the desired time with the “+/-” buttons between 0 and 180 minutes. The
appliance automatically turns off after the time elapses.
5) Switching off
1. After you are finished cooking, switch off the induction hob by pressing the on/off button; the display will
show “OFF”. The fan will still run for a while to cool the appliance.
2. When the fan stops, disconnect the appliance from the power outlet and let it cool entirely.
Child lock
• LOCK: Press briefly the „Lock“ button (lock), the indicator Lock (Child lock) lights up on the display.
•
UNLOCK:
Press the button „Lock“ for 3 seconds. The lock indicator on the display
Lock
goes off, the lock
is deactivated.
CLEANING AND MAINTENANCE
Before cleaning and during any manipulation with the induction cooktop, unplug the power cord plug and let
the cooktop cool down!
Keep the cooktop out of the reach of children while it‘s cooling!
After cooling, clean the glass-ceramic surface and the cooktop control panel with a cloth and use a slightly
damp cloth with a dishwashing detergent for dirtier areas.
Do not use coarse sponges or cleaning powder. Do not immerse the induction hob and the power cord in
water!
Keep the cooktop surface clean at all times to prevent dirt from settling in the fan area causing its subsequent
failure. Use a cotton swab or a toothbrush with a small amount of non-aggressive cleaning agent to remove
dust from areas near the air intake and exhaust openings and carefully remove any oil spots.
Carefully wipe off any detergent residues from the cooktop with a damp cloth, otherwise they may burn when
the cooktop is turned on.
WARNINGS
If the display shows a warning message, follow the instructions below.
Warning code Possible cause Solution
EO
An unsuitable pot/pan is on the
induction zone or the diameter of the
pot/pan is less than 12 cm.
Place suitable cookware on the cooktop.
E1 Bad connection of the induction hob/
faulty electrical circuit.
Contact an authorized service center.
E2 Problem with the temperature sensor. Contact an authorized service center.