![background image](http://html1.mh-extra.com/html/ecg/ewf-1053-md/ewf-1053-md_instruction-manual_3963404009.webp)
English
English
9
•
To prevent water leakage into the joints, 1 or 2 nuts are supplied in the hose package (depending on the
model of your washing machine). Attach these nuts to the end of the supply hose that connects to the
water supply.
2. Connect the new supply hoses to the ¾ ˝ threaded water tap.
•
Connect the white end of the supply hose to the white supply valve on the back of the washing machine
and the red end of the hose to the red supply valve (if used).
•
Tighten the joints manually. If in doubt, contact a qualified plumber.
•
Water flow with a pressure of 0.1 1, MPA will allow your washing machine to work with optimal efficiency
(pressure 0.1, MPA means that more than 8 liters of water per minute flow through a fully open tap).
3. Once all connections have been made, turn on the water supply and check for leaks carefully.
4. Make sure that new water supply hoses are not pinched, kinked, twisted, bent or crushed.
•
If your washing machine is connected to a hot water supply, the hot water supply temperature should not
be higher than 70° C.
˜
˜
Note:
The washing machine must be connected to the water supply only using the new supplied supply hose.
Old hoses must not be reused.
Connecting water drain hose
•
Connect the drain hose to the stand or to the outlet elbow at the
sink using additional equipment.
•
Never try to extend the drain hose.
•
Do not put the hose for draining water from the washing machine
into a container, bucket or bathtub.
•
Make sure that the drain hose is not bent, kinked, squashed or
extended.
•
The drain hose must not be more than 100 cm from the ground.
M
in.
60
cm
M
ax.
100
cm
Summary of Contents for EWF 1053 MD
Page 2: ......