ECG EDS 6006 QXA++, Instruction Manual

Page: 107 / 116

GB
107 107
107
After fi nishing washing
After fi nishing the work cycle, the dishwasher emits six sound signals. Press the power button to switch off the
dishwasher, stop the water supply and open the door of the dishwasher. Before removing the dishes from the
dishwasher, wait a few minutes before handling the dishes while they are still hot and there is a greater risk of
breakage. Also, the dishes dry better.
STARTING THE WASH PROGRAM
TABLE OF WASH PROGRAMS
Programme
Information for program
selection
Program
description
Detergent
Pre-wash/
wash
Program
length
(min.)
Energy
consumption
(kWh)
Water
consumption
(l)
Intensive
For heavily soiled pots and
pans and dishes with dried
food remains.
Pre-wash
Wash (60 °C)
Rinse 1
Rinse 2
Hot rinse
Drying
5/25 g
(or 3in1)
180 1.30 16
Eco
(*EN 50242)
(standard
program)
For normally soiled loads,
such as pots, plates, glasses
and lightly dirty pans.
Standard daily cycle. Pre-wash
Wash (46 °C)
Hot rinse
Drying
5/25 g
(or 3in1)
199 0.92 11
Light
Light washing program
is suitable for delicate
dishes, sensitive to high
temperatures. (Start
immediately after using the
dishes)
Pre-wash
Wash (45 °C)
Hot rinse
Drying
5/20 g
(or 3in1)
137 0.85 14
60 min
Lightly and normally soiled
glasses, plates or bowls,
everyday washing.
Hot rinse 1
Hot rinse 2
Wash (60 °C)
Hot rinse
Drying
5/20 g 60 0.95 10
Fast
Short wash for lightly
dirtied dishes, which are not
necessary to dry.
Wash (40 °C)
Hot rinse
15 g 39 0.50 7
Rinse
To rinse dishes, which you
want to wash later.
Pre-wash / 11 0.01 4
* EN 50242: this program is a testing cycle.
Information for comparative test in accordance with EN 50242 is as follows:
•
Capacity: 14 sets
• Upper basket position: Bottom position
• Setting of rinse-aid dispenser: 5 (or 4 for dispenser with four positions)
SWITCHING ON THE APPLIANCE
Starting the wash program
1. Fill both baskets with dishes and load them back.
We recommend to fi ll fi rst the bottom basket and then the upper one (see chapter „Control panel“).
2. Add the detergent (see chapters on dosage).
3. Connect the power cord to a suitable power outlet, see rating plate of the appliance. Check, if the water
supply is fully open.
4. Make sure that nothing prevents the spray arms from moving and close the door.