English
English
21
4. Reassemble the filters in the reverse order of disassembly, replace the filter insert and turn it clockwise to
the closing arrow.
WARNING:
•
Do not tighten the filters too much. Put the filters back in the correct order, otherwise coarse dirt could
enter the dishwasher and cause a blockage.
•
Never use the dishwasher without the filters in place. Incorrect replacement of a filter may reduce the
performance of the appliance and damage dishes and the appliance.
Spray arms
Regular cleaning of the spray arms of chemicals from hard water is important because emerging limescale
clogs jets and bearings.
To clean the washer arms, follow the instructions below:
1. To remove the upper washer arm, hold the nut in the middle and turn the washer arm counterclockwise.
2. To remove the lower spray arm, pull it upwards.
3. Rinse the spray arms in warm, soapy water and clean the jets using a soft brush.
TROUBLESHOOTING
Before calling the service centre
If you read the content of the tables on the following pages, you may not need to call the service centre.
Problem
Possible cause
What to do
The dishwasher does not start.
A blown fuse or circuit breaker
has blown the circuit.
Replace the fuse or switch back
the breaker. Disconnect all other
electrical appliances sharing
the same mains circuit with the
dishwasher.
The power is not on.
Make sure the dishwasher
is turned on and the door is
properly closed. Make sure that
the power cord plug is securely
plugged into the wall outlet.
Water pressure is low.
Make sure the water supply is
connected properly and the
supply valve is open.
The dishwasher door is not
properly closed.
Check that the door is properly
closed.
No water is drained from the
dishwasher.
Over-twisted or trapped drain
hose.
Check the drain hose.
The filter is clogged.
Check the filtration system.
The kitchen sink is clogged.
Check the kitchen sink to make
sure it drains well. If the water
does not drain from the sink,
contact a plumber.
