English
English
20
•
Washing dishes in a household dishwasher usually uses less energy and water than washing dishes by
hand, if the household dishwasher is used as instructed.
Program start
1. Pull out both baskets, fill them with dishes and load them back. We recommend filling the lower basket
first and then the upper one.
2. Insert detergent.
3. Connect the power supply to a mains outlet. See the product information sheet for power supply
information. Check that the water supply is fully open.
4. Close the door and press the power button.
5. Select a programme, the response light will come on. Then press the Start/Pause button and the
dishwasher starts the wash cycle.
Changing the programme during washing
The programme can only be changed if it has only been running for a short period of time, otherwise detergent
may have already been released or water and detergent have already been discharged. The dishwasher should
then be switched off and the detergent tank refilled. To reset the dishwasher, follow the instructions below:
1. By pressing the Start/Pause button, you stop the wash cycle.
2. Press the Programme button for more than three seconds and the appliance will switch to the programme
selection mode.
3. You can change the programme to the desired cycle setting.
MAINTENANCE AND CLEANING
Exterior of the appliance
Doors and door seals
Clean the door seals regularly with a soft, damp cloth to remove food deposits. When the dishwasher is being
filled, food and drink residues may drip down the sides of the dishwasher door. These areas are outside the
wash cabinet and water from the spray arms cannot reach them. Any deposits must be wiped off before
closing the door.
Control panel
If cleaning is required, wipe the control panel with a soft damp cloth only.
WARNING:
Do not use any spray cleaners, they could cause water to enter the door lock and electrical components. Never
use abrasive cleaners or steel wools on external surfaces as they may scratch the surface. Some paper towels
can also scratch or leave marks on the surface.
Inside of the appliance
Filtration system
A filtration system at the bottom of the wash cabinet collects coarse dirt from the wash cycle, including foreign
objects such as toothpicks or shards. The collected coarse dirt can cause clogging of the filters. Regularly check
the condition of the filters, carefully remove foreign objects and clean parts of the filtration system with water
if necessary. Follow the instructions below to clean the filter.
1. Hold the coarse filter and turn it counterclockwise to unlock it. Lift the filter up and remove it from the
dishwasher.
2. The fine filter can be removed from the bottom of the filtration assembly. The coarse filter can be separated
from the main filter by gently pressing the tabs at the top and pulling it out.
3. Larger food residues can be cleaned by rinsing the filter under running water. For a more thorough
cleaning, use a soft cleaning brush.
