![background image](http://html.mh-extra.com/html/ecg/dvp-7709-white/dvp-7709-white_instruction-manual_531223103.webp)
103
EN
TROUBLE SHOOTING
Before taking this device for repair, check fi rst the following table:
Problem
Cause
Correction
No power.
• The power adapter is not plugged
in the device or in the wall outlet.
• The device is turned off .
• Plug the power adapter in the outlet (AC/
DC adapter) or in the cigarette lighter in
the automobile (auto adapter).
• Make sure that the device is on.
Picture
There is no picture
on the connected
TV set.
• TV set and the player are not
connected properly with the AV
cable.
• Connect the AV jack on the player to the
corresponding AV input on the TV set.
Sound
No audio.
• The volume is set to min.
• The sound is muted.
• The disc is in fast forward/rewind
mode.
• Headphones are connected.
• Increase the volume.
• Press
[
MUTE
] to switch the audio on.
• Press
[
PLAY
] to resume normal playback.
• Disconnect the headphones, the
speakers will play the audio.
Cannot play disc.
• The disk is inserted improperly.
• The disk is not compatible with
this device.
• The disk is contaminated.
• Make sure the disk is inserted with the
label facing upward.
• Use a compatible disc.
• Clean the disc.
The device stops
working when
you insert a
USB drive or a
memory card.
• The connected USB drive or the
card are probably not the certifi ed
kind.
• The device cannot play non-certifi ed USB
drives and memory cards.
In case that the player stops playing,
switch it off , unplug it and remove the
USB drive/memory card. Turn the device
back on. Normal functioning of the
player will resume.
The remote
control does not
work.
• There are no batteries in the
remote control.
• The batteries are dead.
• The remote control is not directed
at the remote control sensor.
• The remote control is outside of
its operating range.
• The device is turned off .
• Insert new battery CR2025.
• Replace old battery for new one.
• Make sure the remote control is directed
at the remote control sensor.
• Make sure the remote controller is close
enough to the device.
• Turn the device off and unplug from the
socket. Turn the device back on.