ECG BD 25, Instruction Manual

Page: 27 / 32

27
EN
Fig. 5
Cleaning mode
This function is used to remove the liquid from the device, whether to replace the liquid or to clean the
container.
1. Hold buttons “+” and “-” for three seconds, the device will dispense liquid for a 30 seconds. The “RINSE”
icon will begin fl ashing on the LCD display (fi g. 6).
2. Repeat the process until the container is emptied.
3. For best results, repeat the rinsing cycle by adding water to the container.
Fig. 6
BATTERIES
1. Only use the designated batteries that best suit this device.
2. Always replace dead batteries at once.
3. Wipe the battery contacts and the device contacts before inserting new batteries.
4. Ensure the battery polarities are correct (+ and -).
5. Remove batteries from the device if you do not plan to use the device for a longer period of time.
6. Immediately remove and dispose of dead batteries.
ATTENTION: Keep batteries away from children. Batteries and screws can be inhaled or swallowed.
Seek immediate medical attention if the battery is swallowed. Do not take the battery apart,
do not throw into fi re or charge. Do not use old and new batteries at the same time.
CLEANING AND MAINTENANCE
1. Only use a dry towel to clean the surface of the product. Clean and container, drip tray and nozzle with a
damp towel and then wipe dry.
2. Do not use any corrosive or abrasive agents.
3. If you do not plan on using the device for a longer period of time, run the rinsing cycle to remove the
liquid from the container. This prevents the liquid from drying and clogging the dispenser mechanism
and nozzle, and even from causing damage to the device.
4. Remove the batteries, leaving the batteries inside a device not used for a longer period of time may
cause damage and even destroy the device.
5. Keep the device in a dry place after completely drying.
TROUBLESHOOTING
The device does not release doses, the motor does not run
1. Make sure the dosage is not set to the POWER OFF position.
2. Place your hands between the nozzle and motion detector.
3. Make sure the batteries are inserted properly.